The use of electric power construction safety rope

by:SanTong     2021-02-04
Electric power maintenance field, high homework, overlapping cross homework very much. In order to prevent the operators in a certain height and position of possible fall, operators, when working in the high and of higher must hang the safety belt. Seat belt use and maintenance of the following requirements: 1. Must pay attention to ideological seat belts. Countless examples proved that the seat belt is & quot; Help with & quot; 。 But there are a few people think wearing a seatbelt, walking up and down is not easy, especially in some small live, temporary work, think 'wear your seat belt, live is done'. Little imagine, accident happened in a flash, fasten your seat belt must be in accordance with the provisions, requirements so high. 2. Seat belts before use should check whether there is rope with the no metamorphism, snap ring crack, spring bounce sex are in good condition. 3. Fixed hanging on a high work such as seat belts, should use appropriate strength of steel wire rope or other methods. Ban hang the safety belt can move in or with sharp tax spindle Angle or unstable. 4. High hanging low. Hang your seat belt on high, and people in the following work is called high hanging low. This is a more safe and reasonable scientific method to hang. It can make fall occurs when the actual impact of distance is reduced. The opposite is low hanging high. Seat belt is fastened in the lower, and people work on it. This is a very unsafe way to hang, because when the crash occurred, the actual impact of distance increased, and the rope will be a larger impact load. So the seat belt must be high hang low in, put an end to low hanging high. 5. Your seat belt is fastened on the solid component or object, to prevent swinging or collision, the rope knot can't use, hooks to hang on the link. 6. Seat belt rope case to keep in good condition, in case the rope frayed. If found that the case of damage or loss, must be combined with a new set of after use. 7. Seat belts are strictly prohibited without authorization after long use. If you use more than 3 m and the ball must be added when buffers, parts shall not be arbitrarily dismantled. 8. Seat belts before use to check whether each part is in good condition. Also should pay attention to maintenance and custody after use. Always check the sewing part of seat belts and the hook part, must be inspected twisting whether breaking, and the damage has occurred. 9. Seat belts when not in use shall be properly kept, and not to be exposed to high temperature, flame, strong acid, strong alkali or sharp objects, do not store in damp warehouse keeping. 10. Seat belt in the use of two years should be to sample at a time, frequent use should be regular appearance inspection, found that abnormal must be replaced immediately. On a regular basis or sampling test used seat belt, not to continue to use again.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...